![]() ![]() * CODING INFORMATION CONTAINED HEREIN IN CONNECTION WITH THEIR PRODUCTS. * FROM THE CONTENT OF SUCH FIRMWARE AND/OR THE USE MADE BY CUSTOMERS OF THE * DIRECT, INDIRECT OR CONSEQUENTIAL DAMAGES WITH RESPECT TO ANY CLAIMS ARISING AS A RESULT, QD electronic SHALL NOT BE HELD LIABLE FOR ANY * WITH CODING INFORMATION REGARDING THEIR PRODUCTS IN ORDER FOR THEM TO SAVE * THE PRESENT FIRMWARE WHICH IS FOR GUIDANCE ONLY AIMS AT PROVIDING CUSTOMERS Remember to set the pins to suit your display module! other pins can be defined by youself,for example If you don't need to control the LED pin, you can set it to 3.3V and set the pin definition to -1. The SDA pin and SCK pin are defined by the system and can't be modified. when using the BREAKOUT BOARD only and using these hardware spi lines to the LCD, Of the library with a supported display module. This program is a demo of how to use most of the functions CONFIGURED FOR EITHER THE TFT SHIELD OR THE BREAKOUT BOARD. IMPORTANT: LCDWIKI_SPI LIBRARY MUST BE SPECIFICALLY Now copy the following code and upload it to Arduino IDE Software. Here is a simple step-by-step guide on “ How to Add Libraries in Arduino IDE“. Installing Librariesīefore you start uploading a code, download and unzip the following libraries at /Progam Files(x86)/Arduino/Libraries (default), in order to use the sensor with the Arduino board. Here is a simple step-by-step guide on “ How to install Arduino IDE“. First, you need to install Arduino IDE Software from its official website Arduino. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |